How to quickly and cleanly remove thermal paste

Share on facebook
Facebook
Share on twitter
Twitter
Share on linkedin
LinkedIn
Share on reddit
Reddit
Share on telegram
Telegram
Share on email
Email

So you’ve recently decided to peel back your CPU cooler and look at the thermally-conductive paste, or what’s left of it, stuck beneath. You brave PC builder, you. And now you want it gone.

Since you might be reading this with a phone in one hand and a messy CPU in the other, I’m going to cut to the chase: The easiest way to clean up old thermal paste is a paper towel.

Now some may say that near-infinitesimally small fibres from the paper towel will stick to the heat spreader and prevent adequate cooling, but so long as you’re not rubbing the paper towel to tatters, you’ll probably be just fine. We do it all the time at PC Gamer towers when we’re switching chips and have never run into any trouble.

That said, when we really want to ensure a completely clean contact point, for thermal testing, we use a microfibre cloth to remove all the gunk with the minimal chance of leaving anything else behind. And when we really want to go the extra mile, we use a CPU cleaning solution or wipe.

The one we use at PC Gamer is called ArctiClean, and it comes in two parts. One part clears away the old thermal paste, and the other “purifies” the surface. Essentially you give the heat spreader a good spring cleaning. A microfibre cloth also works well here.

Better safe than sorry

The key to any CPU cleaning, especially once removed from the motherboard, is to hold only it by the edges and avoid touching any of the contact pads or pins on the underside of the chip. 

It’s pretty unlikely you’ll do any damage to your chip being even moderately careful about it, especially when it comes to CPUs with pads rather than pins, such as Intel’s (and AMD’s upcoming Zen 4 chips). But it pays to take things a little slower when you’re dealing with expensive and sensitive PC parts.

Article source: PCGamer

You might also enjoy